The living standards and environmental conditions of a family can often be seen from the attire of the interior doors, and whether the door cover is installed has also become a crucial part. The role of the interior door cover is not only to beautify the room, but also to fully protect the wall from damage. So, how should the interior door cover be installed?
Installation steps: find a place and bounce
First determine the elevation of the installation of the interior door cover. According to the design drawing requirements, find the elevation, plane position, and vertical size, and then spring the line.
Installation steps: check reserved holes and embedded parts
After springing the line, carefully check whether the spacing, size and position of the embedded wooden bricks meet the installation requirements. At the same time, it is best to measure the position of the reserved door hole again to see if its size is vertical and square, and whether there is any place that does not meet the design requirements.
Installation steps: install wooden door keel
The wooden door keel should be firmly nailed to the fixing parts, and its surface should be flat and smooth, and the effect after installation should be flat and vertical.
Installation steps: lining board nailing
In order to make the installation of the interior door cover more tight, it is best to install the lining board, use wood core board or nine PCT board, and nail them to the wood keel. The installation requirements of the lining board are also relatively strict. It should be inside and then outside. After the installation is completed, the surface should be flat, and the joint position should be straight and without misalignment, so that the nailing can be more secure.
Installation steps: panel nailing
The panel of the interior door cover should be selected in advance with color and pattern, and it is best to match the wall and furniture inside the room, so that after the installation is completed, the wood grain color is more coordinated and unified. Then prepare the cutting board, draw lines on the board according to the keel and cut the board, and plan the surface of the original wood. If you choose to glue the board, the surface of the board generally does not need to be planed, just scrape straight, and the root of the wood grain is down. The face and back of the raw wood need to be made with a relief groove, which can effectively prevent the board surface from distortion and other problems.
Installation steps: door frame installation
When installing the door frame, first confirm the opening direction of the door leaf, so as to determine the cutting direction of the door frame installation. After putting the assembled interior door cover into the door hole, be sure to use a wooden wedge to temporarily fix the door frame. Then use a wire drop to check the overall verticality of the door frame in time to see if it meets the installation requirements.
