Fire door is one of the important fire protection tools. Its design and material composition are very critical. Today I will introduce the working principle of the fire door release switch:
The fire door release switch (reference model: ZDK-905) weighs about 1Kg and has a size of 150*150*50, similar to the 86 series switch panel, usually installed on the wall or on a self-made bracket, with a height of about 1.5 meters from the ground. The method is similar to ordinary wall switches, except that the dedicated junction box must be pre-embedded and sturdy, because the fire door release switch has to withstand the impact of the door leaf and the external pulling force.
There is a groove on the release switch panel, and the corresponding fire door leaf is equipped with a matching metal small handle. The small handle is usually embedded in the groove of the fire door release switch and is buckled. The fire door release switch pulls the fire door leaf so that the door is in position. Normally open state. There is a chain pull bolt on the fire door release switch, and some products are a button, which can be manually released by pulling or pressing the small metal handle (the door leaf can also be forced to be pulled in an emergency). The fire door leaf depends on the door closer elasticity and the action of the sequencer. Close tightly. The fire door release switch keeps the holding force of the small metal handle adjustable within 10~50Kg.
The fire door release switch is often operated electromagnetically. The power supply can be directly taken from the DC, 24V DC external control power supply of the linkage module. The working current is less than 0.3A and the power-on time is less than 0.5 seconds. After the fire door is released, the coil circuit is automatically cut off at the same time. Since fire doors are generally linked by smoke detectors, the probability of closing multiple fire doors at the same time is small, so the impact on the DC external control power supply is not large. When there are many fire doors under control, the external control power supply should increase its capacity.
The fire door release switch is a five-wire system, with two coil wires and three feedback signal wires. One normally closed and one normally open contact reflects the working status of the fire door.
Another type of fire door release switch adopts temperature control, using memory alloy as the temperature control. When the ambient temperature reaches 70 degrees Celsius, the temperature control element will actuate the locking piece to release, and the fire door will close under the elastic force of the door closer. The principle is similar to that of a fire damper.
There is also a composite product called a thermoelectric dual-control fire door release switch (reference model: ZDK-902), as the name implies.
The fire door release switch introduced above is not energized under normal conditions, and is only energized instantaneously during linkage.







