Quality Problems And Inspection Methods Of Steel Fire Doors

Sep 06, 2021 Leave a message

Steel fire doors are widely used in safe passages. Its quality is related to the life safety of many people at critical moments. Therefore, we should not underestimate the problems that arise in the production and installation of fire doors.


1. The quality of raw materials: cut corners and cut corners to make them shoddy. Such as the use of thin plates instead of thick plates, cold rolling instead of galvanizing, and fire and heat insulation materials are not filled.


The inspection methods are: one method is to tap and listen to the sound inspection method. A dull sound indicates that there is filler in the door frame and door leaf. Check each hole (hinge hole, key hole, bolt hole, door closer sequencer fixing hole, upper and lower ventilation holes, process holes, etc.).


Second, the problem of escape locks: The special escape locks can open the door by simply touching the lock body with the body when the personnel escape. Even if there is a fire, the fire door can be opened in case of crowded people at the door to achieve the purpose of escape.


Check whether this special lock is used and flexibility. Under normal circumstances, the emergency evacuation escape door is not allowed to open the door frequently from the outside to enter, and it is not allowed to set the sill above the ground to prevent the escape personnel from tripping during the emergency evacuation.


3. The thickness of the door leaf: The door leaf actually used on the project site is generally smaller than the thickness of the door leaf at the time of design or inspection, and it is difficult to achieve the fire protection level required by the building. Check whether the actual door leaf thickness meets the door leaf thickness in the test report.